|View Larger Image||
Power Carver ---Entry level engraver
SPECIAL OFFER400,000 RPM Engraver!(1) Power Carver(1) On/Off Switch(1) 5 Burr Sampler(1) (1) Practice Stencil Film(1) Training Tape(1) Operation Manual(1) Burr Catalog The Power Carver requires an air compressor to operate. It requires 2.15 cfm at 45 psi. A small compressor 1 HP with a 4-6 gallon tank or larger will work just fine. You will need to have an inline filtration and water trap within 5 feet of the engraver. If you need any assistance on this please call.